Chasity Melton Paper Holder September 22nd, 2018 - 02:24:58
Hi I found this wood from scrap and want to make a mallet. I draw a hole on center. This is for handle joint. For both side Cut the hole with chisel. This process take some time.
I didn't cut the hole deep because i just want to make sure the hole is precision and then i will drill it. Now, i'm drilling.. I try to drill as much as possible. After drilling it's much easy to trim inside. Trim the excess.
Now for handle. I measure the length that want to trim. The size is, follow the hole i cut before. I saw the line that want to trim.. and then trim with chisel.
Here i plane the surface with electric planer. I trim the edge with chisel. I also draw the line before trim for more consistent. It done. I had make many before. Thanks for watching.
Actually i make too loose for this one. The solution is put some cardboard inside no need glue. I use it for long time without problem.